Everything below concerns DAC group. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-03-23. Numbers and descriptions here follow the published literature rather than marketing material.
Lyophilized peptide powder is comparatively stable when kept dry, cold, and protected from light. Once dissolved, the molecule is vulnerable to deamidation, oxidation, and aggregation, with the rate depending on pH, buffer composition, and temperature. Alkaline conditions and repeated freeze-thaw cycles accelerate loss of the intact peptide. The methionine present in the native sequence is a known oxidation site, which is one reason it was replaced in the modified fragment. Suppliers typically recommend cold storage of solutions and use within a short window.
Analytical confirmation usually relies on reversed-phase high-performance liquid chromatography for purity and on liquid chromatography coupled to mass spectrometry for identity. Mass data reveal the expected molecular mass and can flag truncated or oxidized species. Amino acid analysis and peptide mapping provide sequence-level verification. Immunoassays are used in some biological matrices, but antibodies raised against one releasing-hormone analog may cross-react with another. Reported purity figures depend heavily on the method used, so comparisons between suppliers require matching the analytical approach.
Once in circulation, the peptide binds the growth hormone-releasing hormone receptor displayed on pituitary somatotroph cells. Receptor activation couples to Gs proteins, elevates intracellular cyclic AMP, and drives protein kinase A signaling inside the cell. That cascade increases discharge of growth hormone into the bloodstream. The analog therefore operates through a receptor pathway that already exists for the body's own releasing hormone, rather than through an engineered artificial target.
Clearance profiles diverge sharply between the two versions. The albumin-binding molecule stays in plasma for several days, whereas the unmodified analog is largely gone within about half an hour in reported work. Cleavage by dipeptidyl peptidase IV is a major contributor to the short life of the unmodified sequence. These gaps mean the two versions cannot be substituted for each other in study design or in reading results side by side.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | Approximately 3.4 to 3.6 kDa | Depends on whether the affinity complex is attached |
| Appearance | White to off-white lyophilized powder | Freeze-dried solid, often in a sealed vial |
| Solubility | Soluble in water and aqueous buffers | Dissolution rate varies with pH and buffer salt |
| Typical storage | Below minus 20 degrees Celsius, dry and dark | Dissolved material is usually kept cold and used promptly |
| Common analytical methods | Reversed-phase HPLC and mass spectrometry | Peptide mapping and amino acid analysis add sequence detail |
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
CJC-1295 belongs to a class of synthetic peptides modeled on growth hormone releasing hormone, a forty-four amino acid signal produced by the hypothalamus. The compound is built from the first twenty-nine residues of the natural sequence, with four substitutions introduced at positions 2, 8, 15 and 27. These changes were designed to slow enzymatic breakdown while preserving receptor activation. The result is a peptide that is shorter than native GHRH and considerably more resistant to ordinary clearance pathways in circulation.
Two related forms appear under the CJC-1295 name. The simpler analogue, commonly written as modified GRF(1-29), carries the four substitutions but no additional conjugation. The second form attaches a maleimidopropionic acid linker to a lysine residue, a modification frequently called the drug affinity complex. That linker reacts with the free thiol on serum albumin to form a covalent bond. Because albumin has a long residence time in blood, the conjugated peptide stays in circulation far longer than the unconjugated analogue.
Receptor level activity follows the canonical GHRH pathway. The peptide binds the GHRH receptor, a class B G protein coupled receptor on somatotroph cells of the anterior pituitary. Binding raises intracellular cyclic AMP, which promotes calcium entry and the release of growth hormone into the bloodstream. Because the molecule acts at the same receptor as the endogenous hormone, its effect is superimposed on the natural pulsatile rhythm rather than replacing it. Whether sustained receptor occupation leads to desensitization is not fully settled.
CJC-1295 is a synthetic peptide built as a long-acting analogue of growth hormone-releasing hormone. Its backbone matches the first twenty-nine residues of the natural human hormone, with four amino acid substitutions added to slow enzymatic breakdown. A reactive maleimide group, commonly termed the drug affinity complex, allows the peptide to attach to circulating albumin after administration. That albumin attachment keeps the molecule in the bloodstream for an extended period instead of being cleared within minutes.
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
Two forms circulate in research settings and are frequently confused. One carries the drug affinity complex and is often written as CJC-1295 with DAC; the other lacks that group and is usually called modified GRF(1-29). The two share the same core sequence but differ sharply in how long they persist in blood. Products labelled only as CJC-1295 normally refer to the version carrying the complex. Documentation that omits the distinction leaves the intended molecule ambiguous.
=== Behavioral disorders === Some studies exist that naltrexone might be beneficial in the treatment of impulse-control disorders such as kleptomania, compulsive gambling, and trichotillomania (compulsive hair pulling); evidence for its effectiveness for gambling is conflicting. A 2008 case-study reported successful use of naltrexone in suppressing and treating an internet pornography addiction.
=== Drying === Once the gelation is completed, the liquid surrounding the silica network is carefully removed and replaced with air, while keeping the aerogel intact. It is crucial that the gel is dried in such a way as to minimize the surface tension within the pores of the solid network. This is typically accomplished through supercritical fluid extraction using supercritical carbon dioxide (scCO2) or freeze-drying.This section briefly describes and compares the processing strategies of supercritical drying and freeze-drying. Gels where the liquid is allowed to evaporate at a natural rate are known as xerogels (i. e. are not aerogels). As the liquid evaporates in such manner, forces caused by surface tensions of the liquid-solid interfaces are enough to destroy the fragile gel network. As a result, xerogels cannot achieve the high porosities and instead peak at lower porosities and exhibit large amounts of shrinkage after drying. To avoid the collapse of fibers during slow solvent evaporation and reduce surface tensions of the liquid-solid interfaces, aerogels can be formed by lyophilization (freeze-drying). Depending on the concentration of the fibers and the temperature to freeze the material, the properties such as porosity of the final aerogel will be affected. In 1931, to develop the first aerogels, Kistler used a process known as supercritical drying which avoids a direct phase change.
=== Parasites === The protozoan parasites that cause the diseases malaria, trypanosomiasis, toxoplasmosis, cryptosporidiosis and leishmaniasis are important human pathogens. Malarial parasites that are resistant to the drugs that are currently available to infections are common and this has led to increased efforts to develop new drugs. Resistance to recently developed drugs such as artemisinin has also been reported. The problem of drug resistance in malaria has driven efforts to develop vaccines. Trypanosomes are parasitic protozoa that cause African trypanosomiasis and Chagas disease (American trypanosomiasis). There are no vaccines to prevent these infections so drugs such as pentamidine and suramin, benznidazole and nifurtimox are used to treat infections. These drugs are effective but infections caused by resistant parasites have been reported. Leishmaniasis is caused by protozoa and is a public health problem in sub-tropical and tropical countries. Drug resistance has "become a major concern". The preferred treatment for leishmaniasis regionally; liposomal amphotericin B is used in the Mediterranean basin and pentavalent antimonials are more commonly used in Africa, South America, Bangladesh, India, and Nepal. Resistance to antibiotics in Leishmania is a relatively recent phenomena. The first reported instance of resistance to antimonials was reported in India in the 1980s.
Sources: en.wikipedia.org
== Structure == Free fatty acid receptor 3 is a member of the G protein-coupled receptor (GPCR) superfamily, characterized by its seven transmembrane alpha-helices. FFAR3 shares significant sequence similarity with FFAR2 but exhibits distinct structural features that influence its ligand specificity and signaling. The receptor's orthosteric binding pocket is formed by transmembrane helices 3, 4, and 5, with key conserved residues such as Arg-185 (5.39), Arg-255 (7.35), His-140 (4.56), and His-242 (6.55) contributing to the binding and recognition of short-chain fatty acids (SCFAs) like acetate, propionate, and butyrate. Notably, FFAR3's binding cavity is more hydrophilic compared to its close relative FFAR2, which affects its ligand interactions. The second extracellular loop is important in modulating ligand selectivity and receptor activation. Additionally, the presence of a His-45 (2.40) is predicted to coordinate allosteric modulators. The human FFAR3 and FFAR2 proteins consist of 346 and 330 amino acids, respectively, and share about a 40% amino acid sequence homology. The two FFARs have been found to form a heteromer complex (i.e., FFAR3 and FFAR2 bind to each other and are activated together by a SC-FA). When stimulated by a SC-FA, the cells expressing both FFAR3 and FFAR2 may form this heterodimer and thereby activate cell signaling pathways and mount responses that differ from those of cells expressing only one of these FFARs.
1702: Pioneering English entomologist Eleanor Glanville captured a butterfly specimen in Lincolnshire, which was subsequently named the Glanville fritillary in her honour. Her extensive butterfly collection impressed fellow entomologist William Vernon, who called Glanville's work "the noblest collection of butterflies, all English, which has sham'd us". Her butterfly specimens became part of early collections in the Natural History Museum. 1702: German astronomer Maria Kirch became the first woman to discover a comet. c. 1702–1744: In Montreal, Canada, French botanist Catherine Jérémie collected plant specimens and studied their properties, sending the specimens and her detailed notes back to scientists in France. 1732: At the age of 20, Italian physicist Laura Bassi became the first female member of the Bologna Academy of Sciences. One month later, she publicly defended her academic theses and received a PhD. Bassi was awarded an honorary position as professor of physics at the University of Bologna. She was the first female physics professor in the world. 1738: French polymath Émilie du Châtelet became the first woman to have a paper published by the Paris Academy, following a contest on the nature of fire. 1740: French polymath Émilie du Châtelet published Institutions de Physique (Foundations of Physics) providing a metaphysical basis for Newtonian physics. 1748: Swedish agronomist Eva Ekeblad became the first female member of the Royal Swedish Academy of Sciences.
=== Shelf life === The shelf life of canned evaporated milk varies according to both its added content and its proportion of fat. For the regular unsweetened product, a shelf life of 15 months may be expected before any noticeable destabilization occurs.
Mercapturic acids are condensation products formed from the coupling of cysteine with aromatic compounds. They are formed as conjugates in the liver and are excreted in the urine. Mercapturic acids are formed as part of xenobiotic metabolism. A glutathione S-transferase first conjugates the foreign compound to glutathione, forming an adduct. The adduct is then converted to the mercapturic acid: the γ-glutamate and glycine residues in the glutathione molecule are removed by gamma-glutamyl transpeptidase and dipeptidases. In the final step, the cystine residue in the conjugate is acetylated. The mercapturic acid is then excreted. Levels of mercapturic acids in urine may be used as an indicator of exposure to, e.g., ethylene dibromide, acrylamide, and terbuthylazine.
Sources: en.wikipedia.org
The version carrying the affinity complex bears a maleimide group that binds serum albumin, which extends its circulation time to several days. The version without it lacks this group and clears within roughly half an hour. The two are chemically related but behave very differently once in the body.
In common usage the name without the affinity complex is often equated with MOD GRF 1-29, a fragment carrying four stabilizing substitutions. Strictly speaking, the term originally referred to the albumin-binding version. The overlap in naming causes frequent ambiguity in both informal and technical writing.
Reversed-phase chromatography separates the peptide from related impurities and yields a purity estimate. Mass spectrometry confirms the molecular mass and detects modifications such as oxidation. Sequence-level checks rely on peptide mapping or amino acid analysis when stronger confirmation is needed.
It acts on the growth hormone-releasing hormone receptor found on pituitary somatotroph cells. Activation of that receptor triggers growth hormone release through a cyclic AMP dependent pathway.